An electric towel rail is a stylish and functional addition to any bathroom. Besides providing the luxury of warm, dry towels, it also adds an element of warmth to your bathroom and aids in reducing humidity. While it may seem like a complicated task, with the right tools and some careful planning, installing an electric towel rail can be a rewarding DIY project. This article aims to provide you with a clear, step-by-step guide to the process, making your installation as smooth as possible.
- Spirit levels
- Rubber mallet
- Grips or adjustable spanners
- Tape measure
- Cordless drill
- PTFE Tape
- Drill bit
Step 1: Choose the Location
Firstly, decide where you'd like to install your towel rail. Consider factors such as ease of access, the proximity to the shower or bathtub, and distance from water sources to comply with safety regulations. Remember, an electric towel rail must be installed outside of the direct splash zone.
Step 2: Mark the Fixing Points
Once you've decided on the location, hold the towel rail up against the wall and mark the fixing points with a pencil. Ensure its level by using a spirit level.
Step 3: Drill the Holes
Next, use a suitable drill bit to make holes at the marks you've made. If you're drilling into tiles, use a tile drill bit to prevent cracking. Once you've drilled the holes, insert the wall plugs provided with your towel rail.
Step 4: Mount the Rail
Screw the brackets into the wall plugs, then hang the towel rail on the brackets according to the manufacturer's instructions. Make sure it's secure.
Step 5: Connect the Heating Element
The heating element is what heats the water in your towel rail. It will usually screw into the bottom of the rail. Be sure to follow the manufacturer's instructions for connecting the heating element.
Step 6: Fill with Inhibitor and Water
Before you fill your towel rail, you'll need to mix a water and inhibitor solution. An inhibitor is a chemical that helps prevent rust and corrosion inside the rail. The typical ratio is 5% inhibitor to 95% water, but check the inhibitor's instructions to be sure. Using a funnel, pour the solution into the rail until it's approximately 90% full. This leaves room for the water to expand when heated.
Step 7: Bleed the Rail
After filling the rail, you'll need to remove any trapped air, a process known as 'bleeding'. The towel rail should have a bleed valve at the top. Open the valve slowly, allowing air to escape until water starts to drip out, then close the valve.
Step 8: Connect the Electricity
Once your towel rail is mounted, filled, and bled, you're ready to connect it to your home's electricity supply. This step should be carried out by a certified electrician to ensure safety and compliance with electrical codes.
Installing an electric towel rail can significantly enhance the comfort and style of your bathroom. With this step-by-step guide, you'll have the know-how to tackle this project. However, remember that working with electricity can be dangerous, and this part of the installation should always be done by a professional. Enjoy the luxury of warm, dry towels and a cosy bathroom with your new electric towel rail.